Geofencing in TISLOG

If a depot is setup with a geofence, the tour and ETA calculation for the estimated time of arrival at the individual stops can start automatically once the truck leaves this area. As soon as the depot is approached again and the truck reaches the geofence, the software automatically performs all the necessary steps for the tour end. The driver no longer has to carry out these actions himself. He can focus on his task as a vehicle driver, while a seamless and error-free flow of information is automatically ensured by TISLOG.

Various processes on the road can also be facilitated with geofences in TISLOG.
For example, if the truck reaches a stop address for loading or unloading and stops there, its arrival is automatically registered when it reaches the corridor marked with geofencing.
Subsequently, further workflows, such as processing the stop or displaying important information in the software, can be started without manual intervention. Once the truck leaves the geofence again, the stop is automatically marked as completed, the approach to the next stop is started and the ETA is updated.
These automations during the tour help to ensure that the dispatcher can always see the current status of the tour and that the driver himself has to perform fewer tasks in the TISLOG mobile app.

Geofences can also be set up for areas that are not part of the planned tour. These include gas stations and workshops, for example. If the vehicle stops in a so-called "stop geofence", the Alertboard automatically generates a corresponding message. This can either be displayed in TISLOG office or sent by e-mail. The message informs the dispatcher in the head office that the planned tour has been interrupted, the driver does not have to call in or write messages.
The delay in the planned arrival time can be taken into account automatically.